Nice medium sized knee mill. 8 X 32 table
3phase, has dedicated static convertor installed can be run from 10A 220V single phase.
Power table feed in X axis, optional (and am told rare) power downfeed on the spindle. Spindle has been sent out to Index (still in business and parts are available) to have the bearings checked and the quill reground to R8 taper. Uses the most common tooling!
Table has a damaged T slot at the very left end nearest the operator, should in no way effect the operation or set up. Table has one spot where a fixture was attached for and extended period of time, cosmetic in nature. Table feed driveshaft has been rebuilt. New belts for head and power down feed. New drawbar.
Comes with the following tooling:
nice english vise on swivel base
assortment of R8 collets
some end mills
manual and parts breakdown!
Machine is ready to go, just knock the dust off and mill! Table squares perfectly to the column, ways are in good shape, no play to speak of.
If you have been considering a mill/drill you might want to consider this instead, very robust older machine that will last a life time.
Unit weighs about 1600 lbs, buyer is responsible for all crating & shipping costs. Prefer local sale in the Phoenix Area. I will crate for cost of materials only. Delivery is available in the Phoenix area for about $75.
Only reason for selling is I was just about given a nearly new mill and don't have room or need for both.
Beevo (aka Bill VanOrden)